This is a terrific inline street filter which can be easily installed in any stock hose or metal fuel line. Simply cut the existing rubber hose line and insert the filter with two hose clamps. If using a metal line, cut the line and using two short lengths of rubber hose and four clamps, insert the filter into the line. Filter uses a sintered bronze filtering element. The filter is washable in solvent but over time should be replaced with a new one. Filters available in three colors and two hose sizes.

This is a very high performance, yet affordable, street filter. Inexpensive Professional Products adapter fittings are available that will allow it to work with 1/4”, 5/16” or 3/8” hose as well as -6 and -8 AN lines. This filter utilizes a fine mesh replaceable screen element and is available in a red/blue finish or highly polished show finish. The filter is small enough (2.4” long x 1.5” diameter) and light enough that it does not normally require a mounting bracket. This filter will flow up to 160 GPH @ 7PSIG and will filter down to 10 microns. The element is washable but over time it should be replaced with a new one which is very inexpensive.

The Competition Inline Filter is designed for racing applications using gasoline or alcohol on carbureted. It has a large, tubular stainless steel screen inside and features 1/2-NPT ports on both ends. There are four tapped holes on the flat side boss that will allow the use of any type of fabricated mounting bracket. Due to the uniqueness of the various applications these type of filters see, most users will want to fabricate their own mounting bracket. This filter will flow 140 GPH at 7 PSIG and 360 GPH at 40 PSIG. It filters to approximately 15 microns. It is 5.4” long x 1.6” in diameter and is all aluminum construction with Viton® “O”-rings. Viton “O”-rings resist nearly any type of fuel and are usually only found in much more expensive fuel filters.