Inline Street Filter

This is a terrific inline street filter which can be easily installed in any stock hose or metal fuel line. Simply cut the existing rubber hose line and insert the filter with two hose clamps. If using a metal line, cut the line and using two short lengths of rubber hose and four clamps, insert the filter into the line. Filter uses a sintered bronze filtering element. The filter is washable in solvent but over time should be replaced with a new one. Filters available in three colors and two hose sizes.

Inline Street Filter

This is a high performance inline street filter that is very affordable. It has 3/8-NPT ports so that a wide variety of our inexpensive adapter fittings can be used to provide connections to 1/4”, 5/16”, or 3/8” fuel hose. Or you can select fittings to connect to either -6 or -8 AN style fuel lines. These filters use a very fine mesh stainless steet filtering screen. These filters are small enough (2.4” long x 1.5” diameter) and light enough that they normally do not require a mounting bracket. These filters flow up to 160 GPH @ 7PSIG and will filter down to 35 microns. Can be used as a prefilter on EFI systems.

Inline Street Filters

This is a high performance inline street filter that is basically the same as the 10210 and 10211 models shown above. These filters are equipped with a -6 AN connection on both the inlet and outlet port. They have the same performance specifications as the 10210 and 10211 and are intended for the same basic uses. These make a great inline fuel filter on carbureted vehicles or can also be used as a prefilter on EFI systems up to about 550 hp. They are available in an anodized red and blue finish or also in a bright aluminum finish with clear anodize for protecton. Mounting bracket is normally not required.

Inline EFI Fuel Filter

This inline filter is designed specifically for EFI systems and features 1/4-NPT inlet and outlet ports. Compare this filter to a Purolator F33144 except for inlet and outlet port configuration. For -6 AN connections use our Powerflow fitting #15239, for -8 AN use #15242 or for 3/8” hose connections use fitting #10244.