These dampers are manufactured to match the dimensions of the stock early (1963-'69) small block Ford dampers. The outside diameter and the thickness are the same. The counterbalance weight matches the stock 28 ounce inches and the overall balance specifications are held tighter than the original O.E. tolerances. The dampers have both the early 3-bolt accessory pulley bolt pattern and the later 4-bolt as well. This will allow the use of late model serpentine drive systems on early engines if desired. The counterweight for this damper is removeable, so if you want to build a neutral balance engine, you can use this damper by simply removing the bolt-in counterweight on the back of the damper.

Spacers required for some applications.
See Spacer Chart

Our SB Ford Dampers have more universal features than any other damper. All SB Ford models are made to the early short length of 3". This allows the use of a late 5.0L engine with a 50 oz. in. damper to be used in an early chassis where front clearance is at a minimum. To fit in late vehicles, we offer a series of spacers to provide the correct front pulley alignment. See link to Spacer Chart below. These Ford dampers also have three sets of timing marks and both 3 and 4-bolt accessory pulley bolt patterns. The plastic insert shown in the photos can be used to center 3-bolt pulleys with a female pilot, or it can be removed to accept 3-bolt pulleys with a male pilot. These dampers are very versatile and can be used on many different Ford engines.

Spacers required for some applications.
See Spacer Chart

These dampers fit all the same applications as our 80006/90006 and 80007/90007. All of the counterweights and adapter spacers used for those dampers work on these dampers. The difference is the 80045/90045 and 80046/90046 are substantially lighter in weight than the other dampers.
Available July 2008.

Pt.No.		Application
80045		Powerforce Street Damper for 28 oz. in. engines
80046		Powerforce Street Damper for 50 oz. in. engines
90045		Powerforce+Plus SFI Spec Damper for 28 oz. in. engines
90046		Powerforce+Plus SFI Spec Damper for 50 oz. in. engines

The 82006 is basically the same as our 80006 damper, and the 82007 is the same as the 80007 application-wise. The difference is these dampers are highly polished stainless steel and have an engraved mark at TDC. Perfect for street rods, street machines, and show vehicles.
Spacers required for some applications.
See Spacer Chart

Pt.No.		Application
82006		Early Small Block 28oz in. counterweight
82007		Late Small Block 50oz in. counterweight